Technor Italsmea RMS 550 EXPLOSSION PROOF


Ruko Serua Indah Residence, Jln. Serua Raya no.9 Reni Jaya - Bojongsari - Depok , Jawa Barat 16517 Telp : 021- 7419460 Fax : 021- 7419460 
Contact Person : Tommy Bhong (08.11111.0694 / 0815.160.6771 / 0859.3976.3399)
Whatsapp : 08.11111.0694, BBM : 7D1DEF31  Skype : tommy.bhong2
Email : Website : &
“ Your Partner to Total Lighting Solution & Green Lighting”

Technor Italsmea RMS 550

Material Stainless Steel AISI 304, 0.8 mm thickness and
transparent part in tempered glass
IP Rating IP66/67
Temperature -30°C to 55°C
& Approvals
Type Examination Certi cate INERIS 01ATEX3002X
GOST Certi cate IT. 04. 00509
Standards EN 60079-15 / EN 60079-0 / EN 61241-0 / EN 61241-1
IEC 60079-15 / IEC 60079-0 / IEC 61241-0 / IEC 61241-1
Ex-code II 3 GD
Ex nA II T5 Tamb. -30°C to 50°C
Ex nA II T4 Tamb -30°C to 55°C
Ex tD A22 T90° Tamb -30°C to 40°C
Ex tD A22 IP66/67 T100° Tamb -30°C to 50°C
Ex tD A22 IP66/67 T105° Tamb -30°C to 55°C
According to European Directive 94/9/EC (ATEX)
For Zone 2 and Zone 22
Gaskets Special cross section tightness gasket, silicon rubber made (close cells) located in housing channel between
body and window frame.
Entries Body complete of two diam. 21mm through holes for cable entries, one complete of metallic plug with lock nut
and gasket, and the other one with plastic plug for dust protection.
Hardware and Screw AISI 304 Stainless Steel external hardware and screws
Lamps RMS Series is suitable for two pins uorescent lamps G13 socket PHILIPS TL-D or equivalent.
(lamps excluded)
Lamps Wattage 18 / 36 W
Ballast High-frequency electronic ballast conforming with EN 60079-15 and IEC 60079-15
Rated operation
voltage (UE)
220-240 V
Frequency 50 ÷ 60 Hz
Power factor > 0,95
Available upon
Suspension mounting kit “G1” AISI 304 made
Pole mounting kit “P12” 1 ½” size AISI 304 made
Wall mounting kit “H1” AISI 304 made
Emergency Service RMS 550 lighting xtures for Emergency Service are available:
RMS 550...PNL/LE-P
Note Very low pollution at the end of operative life time of lighting fixtures. The inorganic materials used for RMS, like
stainless steel and glass, allow a recycle of 95%, only electrical components and insulation of single core wires need
some more care.
No through holes between inside and outside of luminaries, out of holes for power supply cable whatever protected
by a suitable waterproof cable gland (on request). Therefore, during the time, release would be possible where, for
fixing devices, there are through holes and relevant gaskets.